Prof. Dr. Peter Vatter

Mitarbeiterprofil

Es wurden leider keine Projekte gefunden.

Plettke R., Vatter P.:
Comparison of new analytical an numerical approaches to model the three-roll-push-bending process
In: International Journal of Mechatronics and Manufacturing Systems 7 (2014), S. 279-295
ISSN: 1753-1039
DOI: 10.1504/IJMMS.2014.067153

Vatter P., Hildering S., Tsoupis I., Merklein M.:
Development of a damage prediction system for bending and cutting of high strength steels
In: Key Engineering Materials 554-557 (2013), S. 2479-2486
ISSN: 1013-9826
DOI: 10.4028/www.scientific.net/KEM.554-557.2479
Vatter P., Plettke R.:
Geometrical variations of tubes and their impact on freeform bending processes
In: Advanced Materials Research 769 (2013), S. 181-188
ISSN: 1022-6680
DOI: 10.4028/www.scientific.net/AMR.769.181
Vatter P., Plettke R.:
Process model for the design of bent 3-dimensional free-form geometries for the three-roll-push-bending process
In: Procedia CIRP 7 (2013), S. 240-245
ISSN: 2212-8271
DOI: 10.1016/j.procir.2013.05.041
Vatter P., Plettke R., Merklein M.:
New approaches to determine the bending contour of the 3-roll-push-bending process
7th Int. Conf. on Design and Production of Machines and Dies/Molds (Antalya)
In: Kaftanoglu, B. (Hrsg.): 7th Int. Conf. on Design and Production of Machines and Dies/Molds 2013

Merklein M., Vatter P., Plettke R., Grüner M.:
Einfluss der Fließkurve auf den Rohrbiegeradius
In: wt Werkstattstechnik - Online 10 (2012), S. 689-695
ISSN: 1436-4980
Plettke R., Vatter P., Vipavc D.:
Basics of process design for 3d freeform-bending
In: Steel Research International SPL. ISSUE (2012), S. 307-310
ISSN: 1611-3683

Plettke R., Vipavc D., Vatter P.:
Influence factors of three-roll-push-bending
1st Int. Tube and Profile Bending Conf.
In: Tekkaya, A. E. (Hrsg.): Proc. 1st Int. Tube and Profile Bending Conf. 2011

Hagenah H., Vipavc D., Vatter P., Cojutti M., Plettke R.:
Creation of the Data Base for the Process Design of the Three-Roll-Push Bending Process
In: Teti, R. (Hrsg.): 7th CIRP Int. Conf. Intelligent Computation in Manufacturing Engineering 2010
Plettke R., Vatter P., Vipavc D., Cojutti M., Hagenah H.:
Investigation on the Process Parameters and Process Window of "Three-Roll-Push-Bending"
In: Hinduja, S.; Li, L. (Hrsg.): Proc. 36th Matador Conf. 2010